Macwildstar
Member
- Joined
- May 18, 2017
- Messages
- 6
Been collecting scrap for 2 years, more or less. Not into this big time, but I do have a fair amount of gold coated fingers, connections, CPU pins, fingers, some gold Diabetic test strips (800 of them) and some boards with gold on them.
This will be my first time doing this. Not sure how to go about doing it. Someone said I need to clean the green stuff off the circuit boards first. is this true, or is this done to see if there is any more gold underneath it?
I am looking for an easy way to do this. I can set it up to let the stuff sit and soak for as long as necessary, and would like to do it with as few chemicals as is necessary. Any suggestions?
The large pill bottle is about 3/4 full of little fingers, wires, inkjet cartridge gold connector pads, stuff from memory chips,etc.. the stuff inside weighs over 1.5 lbs. Figure it might give me a 2 or 3 grams.
Tried to find a local processor to do this, but unable to locate anyone in our area. so any help appreciated.
Thanks.
This will be my first time doing this. Not sure how to go about doing it. Someone said I need to clean the green stuff off the circuit boards first. is this true, or is this done to see if there is any more gold underneath it?
I am looking for an easy way to do this. I can set it up to let the stuff sit and soak for as long as necessary, and would like to do it with as few chemicals as is necessary. Any suggestions?
The large pill bottle is about 3/4 full of little fingers, wires, inkjet cartridge gold connector pads, stuff from memory chips,etc.. the stuff inside weighs over 1.5 lbs. Figure it might give me a 2 or 3 grams.
Tried to find a local processor to do this, but unable to locate anyone in our area. so any help appreciated.
Thanks.