bigpagoda
Well-known member
Hello,
Finally going to build a fume scrubber so I can get back to some recovery. I think I have a good design but can't figure out how to size the spray nozzles inside my towers. I have read lots of posts about making scrubbers and researched commercial ones online but found no real info on the nozzles themselves. I have tested a bunch of different kinds but there are so many options out there I decided I should just ask what kind you guys use? How critical is the droplet size or does it even matter as long as I am getting enough on the surface of the packing to keep it wet but not getting pooling at the bottom. Any advice is appreciated
Paul
Finally going to build a fume scrubber so I can get back to some recovery. I think I have a good design but can't figure out how to size the spray nozzles inside my towers. I have read lots of posts about making scrubbers and researched commercial ones online but found no real info on the nozzles themselves. I have tested a bunch of different kinds but there are so many options out there I decided I should just ask what kind you guys use? How critical is the droplet size or does it even matter as long as I am getting enough on the surface of the packing to keep it wet but not getting pooling at the bottom. Any advice is appreciated
Paul