I found the features on the GP1A18

Gold Refining Forum

Help Support Gold Refining Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

galody

New member
Joined
Jan 20, 2011
Messages
1
The features of GT-32011 can be summarized as (1)single chip system controller for the lDT R3051 family of processors; (2)features facilitate the implementation of high-performance embedded control systems; (3)16Mhz - 33Mhz CPU interface to: RSO41/51/52/71/81; (4)DRAM controller: 1 - 40 MB directly, device depth supported: 256K - 4M, 1 - 3 banks directly, non-interleave; (5)ROM controller: 1 - 20MB address -space support bank size: 1- 8MB; (6)support for standard and burst ROMs, support for interleave or non interleave; (7)direct interface to external agent/coprocessor; (8)I/O bus follows 8/16 lntel 80186 style; (9)I/O controller: two 8-bit and two 16-bit extemal channels DMA and non-DMA access for the 8-bit channels 8-32 packing and 32-8 unpacking logic for DMA access, round robin arbitration, programmable timing for I/O and control signals, big and little endian support, 16-32 packing and 32-16 unpacking for CPU) Exter-; (10)nal Co-processor accesses; (11)PCMCIA support; through 16-bit I/O bus, using simple glue logic; (12)16-bit to 32-bit packing and 32-bit to 16-bit unpacking, big and little endian support, 256MB address space dedicated for 2 PCMCIA slots; (13)parallel port: supports control for reading and writing from a 16-bit; (14)parallel port; (15)centronics interface: Bi- directional centronics, compliant with IEEE1284, supports DMA and CPU controlled transfers, supports the following modes: compatible; nibble; Byte; ECP; EPP; (16)interrupt controller: 6 external level interrupts (through the PIO pins); (17)10 internal interrupts, individual interrupt mask capability, enabling polling or interrupt- driven systems; (18)general purpose I/O: six programmable Input (interrupts) or Output pins; (19)24-bit timer/counter; (20)in-circuit testing capability; (21)packaged in a 160-pin PQFP.

The DC electerical specifications of (((((link removed))))) are (1)VIH input high voltage: 20 to VDD+05V; (2)VIL input low voltage: -05 to 08V; (3)VOH output high voltage: 24V; (4)VOL output low voltage: 04V; (5)llN input leakage current: -10 to 10μA(VIN = VDD or GND); (6)IOZ 3-state output leakage current: -10 to 10μA(VOUT = VDD or GND); (7)ICC operating current: 200 mA(VDD = 5V Ta=25°C); (8)CINCLK CLK input capacitance: 11 pF; (9)CIN input capacitance: 5pF.
 
Was that written in Venusian :shock:
What exactly does that have to do with gold refining....
 
jimdoc said:
Nothing.Its spam that should be deleted,or at least have the link in it disabled.

Jim

I saw this last night, late, before I went to bed. Thought I'd see how it shook out---not being wise in the way of electronics. You've said enough---he's been banned from the forum, and I've disabled the link.

Harold
 
Thanks Harold,
When they post links on the sneak like that you really have to wonder what they are up to.I don't even click them.They aren't really trying to advertise when it isn't targeted to the forum,like gold and precious metals for here.
My guess is the website is either going to lead to a virus or a scam.

Jim
 
patnor1011 said:
He was here once :) problem is that bad things keep comming back :)
Thanks to your comments, I went back and banned his IP as well. If he comes back, he'll get treated the same way.

Thanks, guys, for being vigilant.

Harold
 

Latest posts

Back
Top