bmackay
Member
- Joined
- Jun 6, 2011
- Messages
- 10
Hello All,
I process large quantities of complete Hard Drives (HDDs) and need the fastest possible form of destruction that does not involve shredding or completely bending the drives.
I basically need a process with a cycle time of less than 10 seconds that leaves the controller board in decent shape but renders the hard drive useless. I have seen all of these machines that you can buy but all of them are too slow or don't do what I need them to do. I have also tried basic drill presses, but they overheat quickly.
Using a large hammer is possible, but I want an easier process than that...
Does anyone have a hydraulic press or another method to do this??
Any help is greatly appreciated!!
I process large quantities of complete Hard Drives (HDDs) and need the fastest possible form of destruction that does not involve shredding or completely bending the drives.
I basically need a process with a cycle time of less than 10 seconds that leaves the controller board in decent shape but renders the hard drive useless. I have seen all of these machines that you can buy but all of them are too slow or don't do what I need them to do. I have also tried basic drill presses, but they overheat quickly.
Using a large hammer is possible, but I want an easier process than that...
Does anyone have a hydraulic press or another method to do this??
Any help is greatly appreciated!!