gaurav_347
Well-known member
- Joined
- Nov 17, 2013
- Messages
- 169
Members,
I am planing to fabricate an incinerator just for ics and chips. The design is based on an idea I got from youtube. I am planning to replicate it but in a smaller size. I will post the link below. The dimensions are as follows:-
Outer dimension - LENGTH 1000MM WIDTH 1200MM HEIGHT 1500MM
Workable dimension- LENGTH 400MM WIDTH 450MM HEIGHT 600MM
The YOUTUBE link:-
https://www.youtube.com/watch?v=ItUgmYoTTUs
This incinerator will be working on waste oil burner or LDO with 1hp fan motor.
I need your valuable comments and ideas for if I should make any changes in the design. The batch size will be 10-15kgs. The chimney will be connected to the centralized venturi scrubber for scrubbing out the fumes. The whole project is costing me roughly USD 600. We can increase the size with marginal increase in costs.
Thanking you,
Gaurav
edit- cant seem to embed youtube link correctly
I am planing to fabricate an incinerator just for ics and chips. The design is based on an idea I got from youtube. I am planning to replicate it but in a smaller size. I will post the link below. The dimensions are as follows:-
Outer dimension - LENGTH 1000MM WIDTH 1200MM HEIGHT 1500MM
Workable dimension- LENGTH 400MM WIDTH 450MM HEIGHT 600MM
The YOUTUBE link:-
https://www.youtube.com/watch?v=ItUgmYoTTUs
This incinerator will be working on waste oil burner or LDO with 1hp fan motor.
I need your valuable comments and ideas for if I should make any changes in the design. The batch size will be 10-15kgs. The chimney will be connected to the centralized venturi scrubber for scrubbing out the fumes. The whole project is costing me roughly USD 600. We can increase the size with marginal increase in costs.
Thanking you,
Gaurav
edit- cant seem to embed youtube link correctly