Non-Chemical Freezing fiber processors?

[aflacglobal]

O.K. That makes two of these same post. Will their be three. :?:

 

[Ian_B]

I'll pipe in about the AP (Acetone Peroxide) as its known on some chemistry forums.

I have actually made this stuff before in a very very small amount just to say that I have done it. I won't get into the mixtures however.

its almost scary how easy the stuff to make but EXTREMELY dangerous

AP is a High explosive the gasses from it expand at something like 5000 feet per second while a speeding bullet is like 1000 or something very much smaller then the explosive.

the London bombings so many years back used a very close cousin of the Acetone peroxide explosive.

If you allow the acetone to evaporate off you should be ok because when your making Acetone peroxide you need to have so many parts of acetone and so many parts of hydrogen peroxide with a very small amount of HCL if you have a larger amount of HCL like you would in Acid Peroxide then the crystals wont form. Why I can't remember but they just won't. But please do some research on acetone peroxide before you try this just so that you feel more comfortable and know what you are dealing with.

one last little tidbit

acetone peroxide when dry is many times more unstable then nitroglycerin is. and just a very small amount in a closed hand I mean like 1 or 2 grams is enough to put in in the emergency room with a belt around your arm

 

[Ian_B]

hi...
im using a secret method which i discovered while experimenting on how to extract the gold wires inside integrated circuits.. by this method, i could get at least 90-95% of all the wire content in an integrated circuit...
but now im still doing some experiments on how to extract them 100%.
my process is absolutely costless and you wont spend even a single centavo. tools and materials to be needed can be found in any ordinary home. you dont have to buy anything... all you need is your stash of integrated circuits especially quad flat packs and ball grid arrays...

good day...

anybody who wants to know the process, please do email me at [email protected]

sorry about the double post but this doesn't pertain to my last post


I'm just going to make a wild stab at what this would be

Grind you IC's up coffee maker on steroids or ball mill

lay out your dust/ choppings on a board that is non magnetic

get a magnet put it in a ziplock back run it over the crushings

and seperate all of your magnetic peices that are hopefully coated in gold from the plastic/ceramic crud then run in a batch of acid peroxide and whatever other purifying processes you use.

then pan as in gold pan with a cooking pot lid the ceramic/plastic IC dust to get any traces of gold.


OR


Crush IC's place in 5 gall pail fill with water skim off the top any gunk from the top or agitate <-- SP?
the bucket litely so the gold sinks to the bottom or top layers depending on what the IC's are made of I'm just guessing that the densities of the metals would be different then the ceramic/plastic shell.

then again treat the metals however you wish

let me know if I'm anywhere near the way you do it and if not post your procedure here.

 

[GeeDub]

let me know if I'm anywhere near the way you do it and if not post your procedure here.

I know this is an old post, but I just found it. Am I the one who is nuts for NOT taking this seriously? I thought this was a total joke. I mean [email protected]?...I-Am-A-Dork...???