edsikes
Well-known member
MarcoP said:
hey marco! that was exactly what i was looking for. i must have overlooked it!!!! lot of good info in there! thank you so much!
Poor Man's AR for Ceramic CPUs
- Thread starter lazersteve
- Start date
Help Support Gold Refining Forum:
hey marco! that was exactly what i was looking for. i must have overlooked it!!!! lot of good info in there! thank you so much!
Tankman
Well-known member
Hi all,
This is the first time for recovering gold from ceramic CPU's, using poor mans AR. I am at the stage now where I have added SMB to the filtered solution. The question I have is, that is it normal to have a ring of very fine black particles at the top of the solution, which is starting to migrate towards the bottom?
This is the first time for recovering gold from ceramic CPU's, using poor mans AR. I am at the stage now where I have added SMB to the filtered solution. The question I have is, that is it normal to have a ring of very fine black particles at the top of the solution, which is starting to migrate towards the bottom?
Geo
Well-known member
You left out a lot of inbetweens there but if I follow you correctly, fine gold particles get trapped on the surface and are held up by surface tension. Use a spray bottle of water set on mist to knock them down. Wait until everything settles or it will just collect up there again.
Tankman
Well-known member
Thank you Geo,
knocking it down with water on the fine mist setting has worked.
knocking it down with water on the fine mist setting has worked.
