A acpeacemaker Well-known member Joined Feb 8, 2011 Messages 895 Location Colorado Apr 3, 2011 #1 Hey, I've had success with these in AP but, I haven't been able to get the corners to budge. I even tried cutting them up. The corners are gold aren't they? Thank you for any suggestions. -Andrew Attachments 20110403171829.jpg 508.7 KB
Hey, I've had success with these in AP but, I haven't been able to get the corners to budge. I even tried cutting them up. The corners are gold aren't they? Thank you for any suggestions. -Andrew
lazersteve Well-known member Moderator Emeritus Joined Feb 27, 2007 Messages 7,334 Location Florida Apr 3, 2011 #2 The outer surface of the component is likely coated with some form of clear coat or protective layer that prevents the AP from penetrating the part. I would recommend shredding or incineration if you are set up for it. Steve
The outer surface of the component is likely coated with some form of clear coat or protective layer that prevents the AP from penetrating the part. I would recommend shredding or incineration if you are set up for it. Steve